djiuser_ZE0hzyF
New
United States
Offline
|
I went to upgrade my firmware, crashed and my Osmo Mobile stopped working.
Should've just left my firmware, at least it worked. As it stand right now my unit is essentially "bricked"...doesn't do anything after trying to get it re-booted for 2+ hours now.
It was showing up in the DJI Go app, but when I click connect, the "camera status light" stays off even though the app says I'm connected. The controls do nothing, nothing works.
If I cancel the red/blue (power off the device, power it back on) the main light is solid red and the Go app says "strong interference detected" and still does nothing. Is there anyway to FORCE an older firmware to the Osmo Mobile? Looking at what the solid red light means on the main indicator shows that "failed firmware update" is a possibility. That and non-DJI authentic batteries are in the unit, which is not the case here...I only have authentic DJI stuff, purchased directly from DJI.
Any ideas/similar issues (I searched the forum for the red/blue light thing and only found a single post about it with no responses/solutions) would be greatly appreciated.
Thanks!
|
|