tilak.conrad
lvl.1
Sri Lanka
Offline
|
Hi
I just unboxed my V2+ - charged all batteries - downloaded windows software, installed drivers, connected up, did the Firmware Upgrade all as per the manual.
Next step is page 115 2.3 in the 1.4 Manual - I am having trouble connecting through the Phantom RC Assistant to configure the Remote Control - followed all the steps - switched on the Remote, the PC, hooked the two up using the cable and launched the Phantom RC Assisitant Software. The loading screen comes up - the red bar starts off at pretty much two thirds (ie below the second w on the www.dji.com) and doesn't move at all beyond that point. Kept it on for maybe 45 mins... If I press the SKIP button then the program launches but all boxes show either nothing or 100%
Sure I've stupidly missed some simple step - can anyone advise what I should do please
TIA
Tilak - total newbie ;)
|
|