Aussiephantom1
lvl.1
Australia
Offline
|
After non use for a while, due to firmware updates leaving my old phone unusable, I decided to buy a new phone, A Samsung S8. . . The drone was working before this update.
When I connected the new phone I pulled back or down, and left and right on control sticks, the drone started up ready to fly.
Then the phone came up with "Firmware needs updating", there was a link on the phone screen, so I clicked on it and the controller updated, I ended up with a green light on the
controller.
I reconnect to the aircraft and get a message on the screen I get told the aircraft firmware was out of date.
I have now tried updating the firmware on the aircraft and the update was aborted, stating the firmware I was updating to was either older or the same as that already being used.
Only now when I turn on the controller I get a flashing red light, it won't connect to the aircraft and tells me the signal strength is very weak......
I have tried going into settings on the controller, with DJI Go and when I look at the status it tells me "Linking to Aircraft" I click on this box and I get a pop up that asks " Check Frequency" I click on OK and It does nothing, I have tried reinstalling firmware on the Controller via USB Cable and it won't link to the DJI Go App......
Yet again DJI's Firmware has turned a functioning drone into a very expensive paperweight, I have now spent more time trying to sort Firmware problems than I have actually spent flying the drone..... very disappointed with this software and drone.....
I have watched all the tutorials on how to link the drone ( God knows I've done it enough so don't need tutoring). . . none of these tell me to do anything I haven't already tried.
|
|