Hey DJI Team,
using the AirUnit with Betaflight FC does work fine and as espected.
But Using the FPV System without any FC (Wing) does not satisfy me.

I have to change Costum OSD manually on changing to a craft without FC. Then there is no Voltage of AirUnit supply shown.

Does the Airunit can measure the voltage supply and show it in the DJI OSD?
Can the Goggle can choose the costum OSD by the serial number of the AirUnit?
So the setting of Custom OSD would be depending on device broadcasting.

Thank you

Best Regards.

Hello,
same problem here. Is it possible to wire a Voltage Sensor to the Serial Port of the Air Unit? What kind of protocol does the sensor have to send so that the Air Unit can interpret the value? I assume 115.200 baud 8N1, only RX at the air unit?
Many thanks,
Magnus