i created 3 waypoints in a loop with an iPad ground station for a quad naza-m v2The quad fly the 3 waypoints and then fly towards the first waypoint
At 15 meters from my home location and 20 meters heigh i get the message "connection failed" on my iPad ground,station.at that moment i am 2 meters away from my btu and my ground end with my iPad
I switchend to att mode on my tx
The firmware of my btu is 1.0.1.3
The firmware of my ground end is 1.0.1.5
The firmware of myair end is 1.1.1
The version of my ground station is 1.4.62



The battery of my ground end is 72 percent

This happende the fith time i tried

What can be the cause of the failed connection?(i suppose it's the connection between ground station and ground end)

i created 3 waypoints in a loop with an iPad ground station for a quad naza-m v2The quad fly the 3 waypoints and then fly towards the first waypoint
At 15 meters from my home location and 20 meters heigh i get the message "connection failed" on my iPad ground,station.at that moment i am 2 meters away from my btu and my ground end with my iPad
I switchend to att mode on my tx
The firmware of my btu is 1.0.1.3
The firmware of my ground end is 1.0.1.5
The firmware of myair end is 1.1.1
The version of my ground station is 1.4.62



The battery of my ground end is 72 percent

This happende the fith time i tried

What can be the cause of the failed connection?(i suppose it's the connection between ground station and ground end)