texasreiner
New
United States
Offline
|
I know this isn't the thread for this but i'm desperate.
Last edited by texasreiner@comcast.net In 2015-1-4 06:58 Editor
Hello. I need help!!! I am receiving this message when I try to Calibrate my new TX with gimbal control.
CFG-ERR
Configuration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration. Re-calibrate your transmitter,and power cycle your controller and check all of the parameters.
I don't know what to do. Also the Transmitter will not spool up the motors. can only control through ground station
I have ttried recalibrate. no luck |
|