Hi,

Please help,

My phantom 3 gimbal is not responding to anything on the flight controller, however the rest of the drone is fine. the gimbal has power as it does its little dance when it turns on however after about 40 seconds it just does nothing and has no power,

The gimbal light indercator is flashing green quickly lots of times then stopping over and over again

Does anyone know whats going on

Cheers

Thomas

I have the same problem, but no solutions.... not yet

Hi. Similar symptoms and signs. Had a crash, broken ribbon, replaced but after the gimbal initiation... It goes limp, no power, green leds flashing intermittently, no signal... Hope there is a solution for this. Wonder if something shortened  out the gimbal board during the crash...

faridzal.harrym Posted at 2016-5-29 13:19
Hi. Similar symptoms and signs. Had a crash, broken ribbon, replaced but after the gimbal initiation ...

Hello friend, I have the same problem in my gimbal, you solved your problem? What is the solution? Thank you

Hello friend, I have the same problem in my gimbal, you solved your problem? What is the solution? Thank you