I have finally found out what is the problem with my M600. When you update the latest firmware on the remote you will start to lose the connection between m600 lightbridge and the controller. After you downgrade the controller firmware it is working but not ideal (there are still bugs). Because of the loss of signal between the drone and the controller I have already had a small accident with M600, the repair cost was 200 eur and DJI did not accept it as their fault. On the GoApp it says safe to fly gps but this is wrong info , because the m600 is in atti mode. I am afraid to fly it because I'm afraid it will crash again!
Yesterday I had to return the M600 to the local dealer because it is not usable and it is very risky to fly. So as I said before they have the same result with firmware. After they have contacted dji support they were given the answer that it is only safe to fly with the latest firmware. My m600 doesn't work with the latest firmware so it is practically #USELESS. I have to work and I'm losing my clients. I think that i will return this useless fan and buy something useful from dji competitors. |