fabien
lvl.2
France
Offline
|
Hi,
The GPS/Compass has a small aluminum box housing for a CAN connector, in the middle of the wire. This is on that connector that the IOSD Mark II shall be connected with a can wire, no matter the plug you use on the IOSD Mark II.
Then, the top end connector of the GPS will connect on the IMU can connector ( same small alu box as on the GPS wire). And only it's top end connector will finally connect to the MCU.
In short :
- PMU and LED on the CAN 2
- IMU, GPS, IOSD, ZEnmuse, Datalink : CAN 1
Hope this helps |
|