Hello guys i bought mavic pro combo last may 19th, so yes it is still new. I wonder is the uploaded test video that i upload normally happened to the other user? Actually i crashed already but i still wanna fly more first then i'll contact service center this week.

Link below. Thanks Guys

I think your gimbal is disconnected or tangled up with one of its rubber band links.. It could also be from a chipped/damaged prop.. Look on youtube

I would not call that normal. Probably you can do a gimbal recalibration. Also check if the gimbal plate is seated properly.

@Mobilecams, thank you!

@Lok Mavic .. well even how many times I recalibrate, it always been like that ... thanks

If you refer to the jiggle no

not normal - I have more and more the feeling that there is no Quality test with DJI.... a shame

The distortion is not normal. I have only had 2-3 single glitches lasting about 0.2 sec each in over 3-4 hours of 2.7K video, and I put those down to rapid acceleration/deceleration or the wind.

Could be compression too.  Try only using 30 FPS next time and see if it happens.  The Mavic does not do well past 30 FPS and things start to look ugly.  I see you are using 60 FPS.

On further inspection, you have two problems...  The uglyness of 60 FPS and something is affecting you gimbal.

Check the gimbal mounts, you can see this if one of the mount points have become dislodged.

Xman1 Posted at 2017-5-26 06:49
Could be compression too.  Try only using 30 FPS next time and see if it happens.  The Mavic does not do well past 30 FPS and things start to look ugly.  I see you are using 60 FPS.

On further inspection, you have two problems...  The uglyness of 60 FPS and something is affecting you gimbal.

This time i tried using 30 fps with 720 HD mode
I think you were right... it's a lot different...

This is called jello effect and it usually results from abnormal vibrations of the camera. Those vibrations can happen when the gimbal is not properly seated, the gimbal plate is faulty or there is another source for vibrations like broken propellers or motors.

Here is a video to check the gimbal rubber bands.

Hi all, i come back again, after struggling with service center and they still not sending one of my mavic's batteries, so i decided to repair it by myself. here is the result and i think it's all normal now. there are no error whatsoever. i also didn't find any problems with my video i just made ... here is the auto track test that i made for the test. Thank you guys for all your feedback.