Does anyone else have any problems woth the new firmware  v 01.03.06.00 ??

eh?  I've got ver 01.04.0602

He is refering to the controller firmware 01.03.06.00 (the latest) for the plus version.

After the update I took the P4P+ out for a test run but it was a very very cold day and each time I moved the controller from the truck to the cold out side I had a lot of problems with the controller but each time I moved the controller back inside the truck it settled down, I think the cold was effecting the electronics. I had flights in weather around the freezing point with old Software/ Firmware no problem, I have to get out when the weathers a little better and retest the new firmware. I have a very high Probability some of the electrical circuits in the controller or display unit are sensitive to low temperatures. I hope the next time I test in better temperatures I do not have any problem with the latest release.

So far so good with the new firmware released, go on!!!

The only question is...: How can install 3rd party apps in my pro plus?
In my work, is very important if can use Dronedeploy or Pix4dcapture, as a example.

Mike FlyCamUY Posted at 2018-2-19 21:18
So far so good with the new firmware released, go on!!!

The only question is...: How can install 3rd party apps in my pro plus?

Something similar as described in this hread.
There is a lot of limitations as discussed in the release thread.